VERTEX Horizontal,Vertical Rotary Tables

Rotary tables are widely used for circular cutting work, setting the angle of a workpiece, boring, spot-facing and similar work.

Available in table diameters from 100mm to 406mm (4" to  16")

Features

1. These rotary tables are made of high density Meehanite
2. Precision bearings are used to provide rigidity and accuracy under load.
3. Worm is hardened and ground. The ratio is 90:1. The work table is graduateda full 360° so that one turn of the handle moves the table through 4°. Micro collar is graduated in steps of 1'min. And vernier scale makes settings down to 10 seconds possible.
4. They are widely used for circular cutting work, angle setting, boring, spot-facing and similar work.
5. Using the Key guide block, the center can be corrected quickly and accurately.
ITEM NO. TESTING OBJECTIVE VARIATION(INCHES)(MM) MAXIMUM TESTED
1 FLATNESS OF CLAMPING SURFACE(CONCAVE) .0006(0.015)
2 PARALLELISM OF CLAMPING SURFACE TO BASE .0008(0.0.02)
3 SQUARENESS OF CLAMPING SURFACE TO ANGLE FACE .0008(0.0.02)
4 TRUE RUNNING OF CLAMPING SURFACE .0006(0.015)
5 TURE RUNNING OF CENTER HOLE MEASURED AT HOLE EDGE .0008(0.0.02)
6 INDEXING ACCURACY OF DIRECT INDEXING MECHANISM MAXIMUM CUMULATIVE SPACING ERROR 45"

 

ORDER NO. Table Base dimension Bolt slots The Load Capacity For Rotary Table Center sleeve Gross Weight kg/lb
Outer diamensions Height
A1 D H H1 A B g Horizontal Vertical
HV-4 70 110 80 85 145 115 12 35KGS 18KGS MT-2 (C)7.5
HV-6 78
3.07
150
5.91
80
3.11
100
3.94
200
7.87
160
6.30
15
0.59
40KGS 20KGS MT-2 (C)13
HV-8 100
3.94
200
7.87
105
4.13
135
5.31
265
10.43
220
8.66
17
0.67
80KGS 40KGS MT-3 (C)26
HV-10 110
4.33
250
9.84
115
4.53
165
6.50
325
12.80
280
11.02
17
0.67
90KGS 50KGS MT-3 (C)37
HV-12 130
5.12
300
11.81
135
5.32
195
7.68
388
15.27
330
12.99
18
0.71
120KGS 60KGS MT-4 (C)70
HV-14 150
5.12
350
13.78
140
5.51
230
9.03
450
17.72
380
14.95
18
0.71
130KGS 70KGS MT-4 (C)92
HV-16 150
5.90
406
15.98
155
6.10
255
10.03
500
16.69
430
16.93
18
0.71
140KGS 60KGS MT-4 (C)122